Skip to main content
← All Resources
Race managementOctober 15, 2026 · 5 min read

How to calibrate a pinewood derby track for lane bias

Last year, before we touched the track, test runs showed half a second between lane 1 and lane 4. Our fast cars run about 2.8 seconds, so that's a huge gap. Pinewood derby track lane bias is real, and most of it can be fixed with levels, shims and tape.

We got the lanes down to around 0.100 to 0.150 seconds from the fastest to the slowest. That's probably within the normal variation, though it's hard to say. Our target is 0.100 seconds or less.

Why lane bias matters more at our derby

We only run lane rotation at the end. Qualifying and the brackets come first, so the lane a car draws decides more of the result. If every car runs every lane the same number of times, the differences average out, and I wrote about that in the lane rotation post. The more of your day that isn't full rotation, the more a slow lane costs someone.

Compare the car to itself

You can't judge a lane from a race, because the cars are different. Compare a car to itself. Run one car four times, once down each lane. If the times come out the same, the track is honest. If one lane is slower, something is wrong there. Fix it, run the car again, and keep going until the four times match.

You can run four cars and rotate them through the lanes instead. It works, but it's harder to keep track of. A cleaner way is to set up a fake race in the software with lane rotation, run it, and read the lane gaps off the results.

Check the start gate first

The biggest cause of our gap was the starting gate. It was out of level by more than an inch. Cars were running into the wall right off the start, and a car that does that takes longer to get up to speed.

If a lane is slow, look at the start first. We shimmed it and added a guide wire to strengthen the start line.

The hard part is that our track goes up and comes down two or three times a year, and the bolts work loose. It would be fine if nobody ever took it apart. This year we're buying all new hardware for it, the bolts, nuts, screws and washers.

Level every joint, then make it straight

We work up and down the ramp, and at every connection we check that it's level, then shim it or tighten the screws. We use a 4 ft level along the track and a short level at the joints. Spirit levels commonly come in 2, 4 and 6 ft lengths, and the short ones, torpedo levels, run about 9 inches.

Then we make it straight. Our gym floor has lines on it, so we line the side of the track up with them and tape the track down wherever it needs it. A small error matters here. A one degree shift over a 38 ft track pushes the far end about 8 inches sideways (38 ft is 456 inches, times 0.0175).

Plan an hour, and bring knee pads

It takes us half an hour to an hour before game time. We're on our hands and knees with duct tape and two levels, going over the whole track. I bring knee pads.

Our track is a plastic DerbyMagic. It's great, and we're very happy with it. It's also getting older, and storage isn't always perfect, so it picks up really slight warps. They have an effect, so we check it every time.

See how you did afterwards

Lane Lab, on the live stats screen in Apex Derby, shows the average time in each lane and how far each is from the others. It calls a lane even under 0.002 seconds and noticeable over 0.005. I don't use it to calibrate. It's for afterwards, to see how well you did, and the more races you've run, the better the data.

If you only fix one thing, fix the start.

Reading